Announcement

Collapse
No announcement yet.

I have a question

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • I have a question

    i have a 96 trans am and when i fill the gas tank full and drive it even somewhat hard, gas will spill out of where you put the gas in and run down the side of the car. what should i do? anyone else had this problem? reply asap. thanks.
    Tanner B.
    '96 Trans Am

  • #2
    I'v enever had that problem. Sounds like a bad gas cap. It's supposed to let air in but not let anything out.
    2002 Electron Blue Vette, 1SC, FE3/Z51, G92 3.15 gears, 308.9 RWHP 321.7 RWTQ (before any mods), SLP headers, Z06 exhaust, MSD Ignition Wires, AC Delco Iridium Spark Plugs, 160 t-stat, lots of ECM tuning

    1995 Z28, many mods, SOLD

    A proud member of the "F-Body Dirty Dozen"

    Comment


    • #3
      i ve never even heard of that before, get a new cap id say.
      1996 Trans Am WS6

      A4, 3" VForce Catback, Corvette C6 rims, Slotted and Drilled Rotors, 160*stat, BMR SFC, HPP3, B&M Shift Kit.

      Comment


      • #4
        Do you have the metal door inside the filler neck?? I would suspect if that was gone and your cap was bad, gas would spill. But if it's still there, then as they said, your culprit is most likely the gas cap.



        In the picture, don't pay attention to the white spray paint.
        94 Black T/A GT, Advanced Induction 355, 3200 stall, built 4L60E, Moser 9", Baer Brakes, Shooting for 11s...

        Comment

        Working...
        X