i am in the process of installing all new speakers in my car.
i have 2 6x9 and 4 6.5
and a 250 watt 4 channel amp
i am keeping factory radio. i bought 2 IEC AULOC modules
i cut out the plastic in the rear panels and mounted the 6x9's to them
took door panels off, and cut out all speakers
ran a power wire from amp to battery
ran a ground
ran a remote wire from 12v ignigtion yellow to amp
i matched the power and ground wires for each set of speakers right at the pigtail in the back of the radio. i matched the correct wires up with the power and ground to it IEC AULOC and plugged the rac cables into it ran them back to the amp turned on my hooked up the speaker i wired into the IEC and nothing the fuse blows. also yesterday the amp wasnt running, but i checked and had avery good ground and power going into the amp. could i have my remoted wire done wrong? what could cause this. did i do this wrong. anyone have a install guide for this? please help i need this done so i can put my car back on the road.
i have 2 6x9 and 4 6.5
and a 250 watt 4 channel amp
i am keeping factory radio. i bought 2 IEC AULOC modules
i cut out the plastic in the rear panels and mounted the 6x9's to them
took door panels off, and cut out all speakers
ran a power wire from amp to battery
ran a ground
ran a remote wire from 12v ignigtion yellow to amp
i matched the power and ground wires for each set of speakers right at the pigtail in the back of the radio. i matched the correct wires up with the power and ground to it IEC AULOC and plugged the rac cables into it ran them back to the amp turned on my hooked up the speaker i wired into the IEC and nothing the fuse blows. also yesterday the amp wasnt running, but i checked and had avery good ground and power going into the amp. could i have my remoted wire done wrong? what could cause this. did i do this wrong. anyone have a install guide for this? please help i need this done so i can put my car back on the road.
Comment