is there a sensor or something that you would have to get welded into your oil pan for this to work? i know the trans temp gauge you have to have the sensor added to your trans pan.
thanks
chris
thanks
chris
-
1996 Trans Am WS6
A4, 3" VForce Catback, Corvette C6 rims, Slotted and Drilled Rotors, 160*stat, BMR SFC, HPP3, B&M Shift Kit.
-
Can you just put it here?
2002 Electron Blue Vette, 1SC, FE3/Z51, G92 3.15 gears, 308.9 RWHP 321.7 RWTQ (before any mods), SLP headers, Z06 exhaust, MSD Ignition Wires, AC Delco Iridium Spark Plugs, 160 t-stat, lots of ECM tuning
1995 Z28, many mods, SOLD
A proud member of the "F-Body Dirty Dozen" -
anyone know where to plug it for ls1?1999 T/A M6 STOCK Slp Loudmouth , SKIPSHIFT ELIMINATOR, KNN FILTER SLP Short Throw Shifter w. slanted short stick, Ram PowerGrip Clutch C6Motorsport Rims w. 285/40 GoodYears
CAR IS SOLD
Comment
-
On the LT1, I put the oil temp sensor in my oil drain plug. Drilled it, tapped it and screwed it in, with a terminal to allow the wire to be removed for oil changes.
I'd be a little concerned about heat soak when putting it in the side of the block... and I already had the -AN line for my mechanical oil pressure gauge in there.
For the trans temp sensor, there is a pressure test port in the side of the 4L60E that can be used.
Fred
381ci all-forged stroker - 10.8:1 - CNC LT4 heads/intake - CC solid roller - MoTeC engine management - 8 LS1 coils - 58mm TB - 78# injectors - 300-shot dry nitrous - TH400 - Gear Vendor O/D - Strange 12-bolt - 4.11's - AS&M headers - duals - Corbeau seat - AutoMeter gauges - roll bar - Spohn suspension - QA1 shocks - a few other odds 'n ends. 800HP/800lb-ft at the flywheel, on a 300-shot. 11.5 @ 117MPH straight motorComment
-
thanks for the help guys.1996 Trans Am WS6
A4, 3" VForce Catback, Corvette C6 rims, Slotted and Drilled Rotors, 160*stat, BMR SFC, HPP3, B&M Shift Kit.
Comment
Comment