Just released from J&M products! I'm curious to get your all's take on these.
http://www.camaroz28.com/articles/jmbushing/
http://www.camaroz28.com/articles/jmbushing/
-
Joe K.
'11 BMW 328i
'10 Matrix S AWD
Previously: '89 Plymouth Sundance Turbo, '98 Camaro V6, '96 Camaro Z28, '99 Camaro Z28, '04 Grand Prix GTP -
I have them...
So far, no squeaks or binding. They are a bit difficult to install. I lubed them up prior to installing, but the ball and socket tends to want to separate as you are installing the arms. I removed them, removed most if not all of the grease, then put them on the car. Once on, I lubed them up with the zerk fitting. The design makes sense, only time will tell if they hold up. The good thing is, J&M warranties the parts for life.Al 96 Ram Air T/A
Mods: Build # 784 * Hotchkis STB * SFCs * Borla cat back w/QTP cut-out * AS&M/RK Sports Mid-length headers w/single CAT * Koni SA shocks on lower perch w/ lowered rear * Strano Hollow front & rear antisway bars * 1LE front/rear springs * 1LE aluminum driveshaft * Strange 4.10 gears w/ Zexel Torsen diff. * ARP bearing cap studs & aluminum diff cover* J&M Hotpart poly/poly rear LCAs and poly/poly panhard bar * RAM Powergrip clutch w/ LT4 PP and RAM billet Al flywheel * C5 Z06 brakes * C6 Z06 wheels * Spohn T/A * Spohn DS Loop * fully custom interior w/ custom audio -
Looks like a great idea.
Comment
Comment