will these rotors work on my car??

[1slo_camaro]

guyz will these work on my 94 v6??? i have front rotors and rear drum


http://washingtondc.craigslist.org/n...551425412.html

[Trash man]

i wanna so no becuz i think the LT1 guys usually upgrade to the LS1 brakes cuz they are better/bigger

[1slo_camaro]

ok i was just curious it was a good looking deal and i thought it would definatly help out also with my 94 v6 could a take a rear out of a 98-02 ss or z28 with disk in the back how much would it take to change it from drum to disk??

[Joe 1320]

You should be able to find a used rear that is complete with brakes for $300-350.

[Trash man]

swap meets and junkyards, any v8 car from 93-02 will fit

[Blazer]

Go here you may find it in your back yard http://www.car-part.com/
Blazer

[1slo_camaro]

alright thanks a million guys!!!

[Joe 1320]

swap meets and junkyards, any v8 car from 93-02 will fit

Also get the driveshaft while you are at it. The V6s use a two piece, the V8s use a one piece.

[Trash man]

ahh yes i forgot bout that part, if u can get a aluminum one

[LarryMow]

swap meets and junkyards, any v8 car from 93-02 will fit

I thought the 98-02 cars had a 4 wire ABS setup and the 93-97 cars had a 3 wire? Wouldnt it make a big difference in order to work properly?

[Joe 1320]

I could be wrong, but I think you are referring to 3 or 4 channel ABS. 3 channel is used when no traction control is installed, there is a single sensor on top of the differential. 4 channel is used with traction control and uses two sensors for the rear, one at each rear wheeel. Maybe someone else can chime in about the possibilty of differences in the wiring.......

[Trash man]

u got it right joe, 4 channel is w/ traction, 3 channel is without, he prob has a 3 channel being a 6 banger and no posi,