Announcement

Collapse
No announcement yet.

New Chip/Module For 96 LT1s?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • New Chip/Module For 96 LT1s?

    Well i ran across these. looking at Summit Store. Would they be any Decent?

    Hypertech has one for 96 to 97 Says

    Hypertech one.
    http://store.summitracing.com/partde...5&autoview=sku

    Jet Module

    Says 1996 to 1996

    http://store.summitracing.com/partde...5&autoview=sku
    1996 Firebird Formula

    | Magnaflow Catback | 17x9 Ws6 Rims | Ram Air Hood |

  • #2
    Not "new" by any means.... been around for over 10 years. Not worth $200-250. For $150, you could have a custom tune, that will guarantee you 10-15HP on a totally stock engine, just from leaning out the overly rich stock programming (PE mode "target" A/F ratio). The full, $350 Hypertch "power programmers" don't do anything. They have been shown in dynoo tests to lose HP over stock, unless you also opt for the 160*F thermostat. These "modules" do even less.
    Fred

    381ci all-forged stroker - 10.8:1 - CNC LT4 heads/intake - CC solid roller - MoTeC engine management - 8 LS1 coils - 58mm TB - 78# injectors - 300-shot dry nitrous - TH400 - Gear Vendor O/D - Strange 12-bolt - 4.11's - AS&M headers - duals - Corbeau seat - AutoMeter gauges - roll bar - Spohn suspension - QA1 shocks - a few other odds 'n ends. 800HP/800lb-ft at the flywheel, on a 300-shot. 11.5 @ 117MPH straight motor

    Comment


    • #3
      Tuners???

      Best programmers I have ever dealt with are at www.pcmforless.com

      Good luck,

      Scott

      Comment


      • #4
        Originally posted by Injuneer
        For $150, you could have a custom tune.
        Where can you get it done for that price?
        Eddie
        2000 M6 Trans Am
        Tune+exhaust=344WHP

        Comment


        • #5
          Check out pcmforless.com, madZ28.com and Trifecta.
          Fred

          381ci all-forged stroker - 10.8:1 - CNC LT4 heads/intake - CC solid roller - MoTeC engine management - 8 LS1 coils - 58mm TB - 78# injectors - 300-shot dry nitrous - TH400 - Gear Vendor O/D - Strange 12-bolt - 4.11's - AS&M headers - duals - Corbeau seat - AutoMeter gauges - roll bar - Spohn suspension - QA1 shocks - a few other odds 'n ends. 800HP/800lb-ft at the flywheel, on a 300-shot. 11.5 @ 117MPH straight motor

          Comment

          Working...
          X