Having some issues with fueling, fixed all the stuff that needed it, now im getting off idle blm splits
I could do the following;
forced open loop by raising open loop thresholds
speed density mode
keep it closed loop maf mode and figure it out painstakingly
I have done a bit of homework here, searched around and tried a few tricks with no results.
Everything mechanical and electrical is in good working order, as far as cl feedback goes.
suggestions..? I have not figured this one out yet, don't have a infrared thermometer for individual trim multipliers. As of right now, i just put the thresholds for cl way up to a temperature range i wont hit.
Thanks again to my favorite f body board
I could do the following;
forced open loop by raising open loop thresholds
speed density mode
keep it closed loop maf mode and figure it out painstakingly
I have done a bit of homework here, searched around and tried a few tricks with no results.
Everything mechanical and electrical is in good working order, as far as cl feedback goes.
suggestions..? I have not figured this one out yet, don't have a infrared thermometer for individual trim multipliers. As of right now, i just put the thresholds for cl way up to a temperature range i wont hit.
Thanks again to my favorite f body board
Comment