I am running a '93 Z28 computer and harness, but just replaced the long block with a 96 LT1. The '93 had been working fine with no CEL. I replaced the long block and used the '96 optispark and the distributor harness. I am now getting a consistent error code of 43. Do you think there is any connection, or should I just put my original knock sensor in to see if that helps? There is a little valve train noise in this motor.
Announcement
Collapse
No announcement yet.
Optispark upgrade Code 43
Collapse
X
-
Put the '93 knock sensor in the '96 block. The sensors have a different resistance. Your '93 ECM is looking for the '93 KS resistance.I'm Bob... 1994 Z28 A4, K&N CAI, 160 T-stat, LT4 Hot Cam, 1.6 RR, Pacesetter LT's, Corsa CatBack, Transmission Perform Switch, 3.42 rear, TunerCat $EE, FreeScan & TTS DataMaster-EE.
Comment