Announcement

Collapse
No announcement yet.

ABS problem

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • ABS problem

    Ok guys, I'm back with the same problem. Replacing the speed sensor hasn't done it and I'm getting tempted to take it in to a dealer and have them fix it. Here's the symptoms again:

    when slowing down, most of the time the low-trac light pops up and the front brakes release and grab again a few moments later; this continues until the ABS Inop light comes on; there are times that it doesn't occur

    Anyone know what the problem might be? I replaced the harness that goes to the sensor, but not the one that goes to the controller. Any ideas or ways to diagnose the problem? Thanks guys.
    Steve
    79 FSJ - most expensive AMC Jeep ever Mods
    87 GN - its just a 6... Mods
    93 Z28 - slightly tweaked Mods
    http://home.comcast.net/~budlopez

  • #2
    Have you had it on the scanner to get codes?
    96 WS6 Formula: Ram Air, 383 Stroker, Ported LT4 Heads and Manifold, 1.6 Crane Rollers, 58MM T.B., AS&M Headers, Borla Exhaust, Meziere Elec. H2O Pump, Canton Deep Sump Oil Pan, 100 HP OF TNT N2O!! , T56 Conversion w/ Pro 5.0 shifter, SPEC Stage 3 Clutch, Hotchkiss Subframe Conn., Lakewood Adj. Panhard Bar, Spohn Adj. LCA's, BMR Adj. T.A., Custom 12 bolt w/ 3:73's, Moser Axles, Eaton Posi, Moser Girdle
    11.6 @ 123mph (1.6 60' - getting there )

    Comment


    • #3
      I had a dealer scan it and it returned that it was the front-right speed sensor. However, having replaced that now 3 times myself and the prev. owner did it once, I don't think its the sensor. Any ideas?
      Steve
      79 FSJ - most expensive AMC Jeep ever Mods
      87 GN - its just a 6... Mods
      93 Z28 - slightly tweaked Mods
      http://home.comcast.net/~budlopez

      Comment

      Working...
      X