Announcement

Collapse
No announcement yet.

3M swirl remover _how to use and where to buy

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • 3M swirl remover _how to use and where to buy

    ok, I have used zaino since the day I picked up the hawk with 8 miles on the odometer back in Aug of 2001...

    even with zaino, Z5 and z2.... and the ZFX, i still cannot cover up numerous annoying spider marks and fine scratches in the clearcoat. I have seen the results of the 3m swirl remover and think its a good product.... when used proplerly. I have a variable rotatating 10" buffer (simulates hand to avoid swirls - the craftsman one) .. but it is not speed variable.. which is needed for the low speeds to no over do it with the 3M swirl remover

    can anyone point me in the right direction.. plan on doing this next march/april when weather allows


    ~~~~~~~~~~~
    (plan on chroming dual/dual this winter as well )
    Rhode Island Red *Lurker since 1997*

    2002 Firehawk #0035/1503 !Cags | !Air | !PCV | Airborn-coated Kooks LT's | Powerbond UD Pulley | Custom Cam | Ported Oil pump | LS2 timing chain | Comp 918's | Hardened push rods | LSS | BMR STB | SLP Bolt-on SFC's | drill mod |TB Bypass | Ported TB | Custom Dyno tuning | 160* thermostat | LS7 Clutch
    Ordered: May 1, 2001 Built: June 1, 2001 Delivered August 25, 2001
    pics and info

  • #2
    I would do a lot of prep work on cleaning as much as possible on the paint such as washing it thoroughly with soap then use wax and silicone remover then carefully clay bar to get as much contaminants out of the paint as possible. (if not dirt will just swirl around the paint) I'd put a new cotton car cover over it if not able to complete in a single day.
    '95 Formula A4, 17"x9" wheels, F1 275/40-ZR17, TB bypass, 160 deg. TS, LS1 drive shaft, WS6 muffler, LCA, tie rod Soon to be LT4 heads intake and HOT cam.

    Comment

    Working...
    X