dynomax bullet muffler

[lt1maro]

I am looking to purchase a dynomax bullet muffler. Does anyone here run one of these, if so how loud is it and how is yours set up.

[Benm109]

I personally don't have one, although I am kinda thinking about it . I have seen and heard some people on a 3rd gen message board that had them on their cars. In my opinion, if you just have one it sounds too loud, but if you have two set up for a true dual system it sounds sick!

Basically, if you want something pretty loud, get them.

[lt1maro]

yeah i dont mind the sound i just wanna know how much some of the guys paid for the set up of the muffler

[MN6WS6]

I've got two back-to-back, and without cats, it's still too loud. It might be alright with full exhaust, but mine stops just after the axle and is extremely loud (stock motor too). Start with two, go up from there. You can usually pick them up on LS1.com for less than $20 a piece including shipping. Welding them in will probably cost you about the same depending on where you are. Cut-cut-weld-weld, 10 minute job.

[lt1maro]

you got a pic of this setup. I was looking to do it with the exhaust exiting out of the back with dual tips

[MN6WS6]

There's not much to take a pic of. Just look at your stock exhaust, between the second cat and the turn up over the rear axle are two bullet mufflers welded back to back. The cats are gone and a pipe welded in their places. Flow is good, sound is bad.