Announcement

Collapse
No announcement yet.

replacing headlights

Collapse
X
Collapse
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous Next
  • #1

    replacing headlights

    ok, i am very confused.

    my drivers side low beam headlight went out this week, and so i decided i was going to try and get HIDs if they dont cost too terribly much. i started looking online, but i ran into a problem.

    the measurments listed online: JCW are all 6" by 8" or 6-1/2" by 4". i measured my cars lights and they were 5-3/4" by 3".

    am i just measuring wrong, or is the site messed up or what? does anybody know where i can go online to get lights?
    Tags: None
  • #2
    You might want to mention the year, make and model of your F-Body, since there has been a huge variety of headlights used since the first F-Bodys in 1967, through the 2002 models.
    Fred

    381ci all-forged stroker - 10.8:1 - CNC LT4 heads/intake - CC solid roller - MoTeC engine management - 8 LS1 coils - 58mm TB - 78# injectors - 300-shot dry nitrous - TH400 - Gear Vendor O/D - Strange 12-bolt - 4.11's - AS&M headers - duals - Corbeau seat - AutoMeter gauges - roll bar - Spohn suspension - QA1 shocks - a few other odds 'n ends. 800HP/800lb-ft at the flywheel, on a 300-shot. 11.5 @ 117MPH straight motor

    Comment

    • #3
      sorry about that
      its a 1993 chevy camaro 3.4L

      Comment

      • #4
        There was a thread about this recently...like in the past week or so. Try a search.
        Joe K.
        '11 BMW 328i
        '10 Matrix S AWD
        Previously: '89 Plymouth Sundance Turbo, '98 Camaro V6, '96 Camaro Z28, '99 Camaro Z28, '04 Grand Prix GTP

        Comment

        Previous Next
        Working...
        X