my pass side valve cover has the oil fill location. mine consists of the very coarsely threaded hole in the valve cover itself, an approximatly 4 inch long fill tube that has coarse threads on one end and the place for the cap too tighten into on the other, and the cap. the cap seats in it's end fine but the other end that appears 2 be 2 threaded into the valve cover ain't right. you can try 2 screw it into the valve cover but there is 2 much clearence between the threads. they touch, but will NEVER get tight . did the last owner get some parts mixed up or is
1) the valve cover wrong i.e hole 2 big
2) filler tube 2 small, for some other application
i do not like using glues or latex or silicone where it can drop into the engine and possiblely get into the oil system.
please educate me here!
thanks
1) the valve cover wrong i.e hole 2 big
2) filler tube 2 small, for some other application
i do not like using glues or latex or silicone where it can drop into the engine and possiblely get into the oil system.
please educate me here!
thanks
Comment